Crystal fires Jewel Service Manual download pdf (Page 19)

ISSUE 1

CLEANING

BEFORE CLEANING ANY PART OF THE FIRE ,ENSURE THAT THE GAS IS TURNED OFF AND

FIRE IS COOL.

BLACK PAINT.

USE ONLY CLEAN DAMP CLOTH ,DO NOT USE ANY CLEANING AGENTS

BRASS TRIM

USE BRASSO,ENSURING YOU REMOVE THE BRASS TRIM FROM THE APPLIANCE BEFORE

CLEANING

IMPORTANT

THE PAINT AND BRASS FINISH ARE DURABLE BUT WILL BE DAMAGED IF

PLASTER,CEMENT,OR WALLPAPER PASTE COMES IN CONTACT WITH IT

COALS AND CERAMICS

IF FOR ANY REASON IT IS NECCESARY TO REMOVE CERAMIC PARTS,THEN BEFORE

REPLACEMENT THE BURNER SHOULD BE CHECKED THAT NO PARTICLES HAVE

DEPOSITED ON THE BURNER AND IF NECCESARY VACUUM THEM CAREFULLY,THEN

REFER TO INSTRUCTIONS FOR REPLACING CERAMICS.

CERAMICS SHOULD BE CLEANED WITH A SOFT BRUSH

THE GEM CAN BE LIT WITH A TAPER SHOULD THE SPARK IGNITION FAIL

TURN THE KNOB TO THE OFF POSITION AND WAIT 3 MINUTES TURN THE KNOB TO THE

IGNITION POSITION AND THEN LIGHT THE PILOT WITH A TAPER

THIS IS ONLY AN EMERGENCY MEASURE AND THE APPLIANCE SHOULD BE

SERVICED AS SOON AS POSSIBLE,THEN PROCEED AS STATED EARLIER FOR OPERATION

THE TAPER SHOULD BE

POSITIONED TO THE PILOT TO

THE FAR RIGHT OF CURVED

FRONT PIECE AND LEVEL

WITH PIECE 1

SHOWN LEVEL WITH THE LINE

BELOW

-----------------------------

1 2 ... 14 15 16 17 18 19 20 21 22 23

No comments

Crystal fires Jewel Service Manual Page 19